Green FabLab Wiki

This is an old revision of the document!

---

Instructions of using the Laser Cutter

In order to use the laser cutter first, you should receive the security and instructions briefing. This laser cutter is operated with computer number 1 that has installed in it Coreldraw: https://www.coreldraw.com/en/. The username and password are provided by the staff.

The first thing to do before starting to operate the laser cutter is to activate it in the control panel by pressing the bottom left button. The control panel can be found on the right wall parallel to the laser cutter.

After that, a special USB stick has to be attached to the laptop (as without it, a failing error occurs when sending prints to the laser cutter) and the cable of the laser cutter itself.

As these are set, it is time we either insert a file (dxf, dwg files recommended) to CorelDraw or create our file directly in the software. Either way, we prepare our file for cutting/engraving depending on the design, opening the following software: