Differences

This shows you the differences between two versions of the page.

--- maschinen:lasercutter [2022/03/09 12:37]
ketlli
+++ maschinen:lasercutter [2022/03/30 09:17] (current)
ketlli
@@ Line 1: / Line 1: @@
-====== Instructions of using the Laser Cutter ======
+====== Instruction manual for the Laser Cutter ======
 In order to use the laser cutter first, you should receive the security and instructions briefing. This laser cutter is operated with computer number 1 that has installed in it [[https://www.coreldraw.com/en/|CorelDraw]]. The username and password are provided by the staff.
@@ Line 41: / Line 41: @@
 {{ :maschinen:e.sendjob.png?direct&400 |}}
+===== Parameters =====
+Last step before pressing start to send the job, is setting up the parameters in the laser cutter menu. When the laser cutter menu pops up, we have to make sure the mirror option in 0 degrees is pressed(red) and to set up the speed(blue). It is also noticed, that in the drop down menu, either cutting on engraving can be selected in case the wrong button was pressed in the laser cutter menu in CorelDraw. Press start and your piece will be ready. Below find the parameters recommended for the different kinds of materials.
+{{ :maschinen:d.parameters.png?direct&400 |}}
+{{ :maschinen:acrylic.png?direct&600 |}}
+{{ :maschinen:mdf.png?direct&600 |}}
+{{ :maschinen:cardboard.png?direct&600 |}}

Green FabLab Wiki