en
deResources
Workshops
Our Facilities
Help
Sidebar
maschinen:cnc
This is an old revision of the document!
Instructions of use for the CNC machine
The CNC machine in use in the GFL is the eas Heavy 450.
Before the use of the machine, a design is necessary. For the following design and process, Fusion360 was used. The steps to be taken in using the machine are:
- The installation of the machine's Post Processor
- The preparation of the design in Fusion360 to be cut
- The actual use of the CNC
Installation of Post Processor
maschinen/cnc.1647618558.txt.gz · Last modified: 2022/03/18 15:49 by ketlli
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
