Resources
Workshops
Our Facilities
Help
Resources
Workshops
Our Facilities
Help
This is an old revision of the document!
The CNC machine in use in the GFL is the eas Heavy 450.
Before the use of the machine, a design is necessary. For the following design and process, Fusion360 was used. The steps to be taken in using the machine are:
The steps to be taken for the installation of the Post Processor for EAS HEAVY 450 are the following:
After the installation of the Post Processor, we can proceed with the design that we wish to cut. In Fusion360, in the Design environment, we use the sketch tool to design the following design, and the extrude tool in order to give our design essence and eventually be able to cut it in the CNC machine.
After we have the design we wish to cut ready, we go to the Manufacture environment and insert the configuration of the milling bit which we have in use or we will use in the CNC machine. In order to insert the milling bit, we follow the steps below: