Differences

This shows you the differences between two versions of the page.

--- maschinen:cnc [2022/03/25 10:01]
ketlli
+++ maschinen:cnc [2022/03/30 09:50] (current)
ketlli
@@ Line 1: / Line 1: @@
-====== Instructions of use for the CNC machine ======
+====== Instruction manual for the CNC machine ======
 The CNC machine in use in the GFL is the eas Heavy 450.
@@ Line 83: / Line 83: @@
 {{ :maschinen:e5piecetobecut.jpeg?direct&600 |}}
+The next step would be to determine the zero point of our CNC machine, where our design will be cut. We can use either the hand controller or the control in the software to do that. We have to set the XY axes and Z axes as set in Fusion360.
+{{ :maschinen:e6handcontroller.jpeg?direct&600 |}}
+{{ :maschinen:e7zeropoint.jpeg?direct&600 |}}
+{{ :maschinen:e8zeropointz.jpeg?direct&600 |}}
+The last thing to do, before we move on to the computer for the start of the machine, is release the knob so that the brush is released in order to have less debris during cutting.
+{{ :maschinen:e9releaseknob.jpeg?direct&600 |}}
+Lastly, we move on to the PC. We open the program following the NC program logo, we insert the file that we have prepared for cutting by File>Open and then we press Start either by pressing the button in the software or in the hand controller. Noticeable is when we open the program, on the right-hand side the control panel for the axes. They can also be moved by the software are mentioned before. For big steps, it is advisable to use the control in the software and for smaller increments, especially for the z-axis, it is better to use the hand controller as the increments there are way smaller. Very important is to make sure to block the doors before we press start, otherwise, the CNC machine will not start.
+{{ :maschinen:a.nc_logo.png?direct&400 |}}
+{{ :maschinen:b.openprogram.png?direct&600 |}}
+{{ :maschinen:c.insertfile.png?direct&600 |}}
+{{ :maschinen:d.startcutting.png?direct&600 |}}
+Lastly, do not leave the CNC machine unattended at any moment while it is working. If needed to go, ask someone else to be there instead. So, finally, after releasing the doors when the CNC was done and vacuuming the leftover debris, this was the end result.
+{{ :maschinen:e10finalresult.jpeg?direct&600 |}}

Green FabLab Wiki

User Tools

Site Tools

Differences

Page Tools