This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
maschinen:cnc [2022/03/25 10:15] ketlli |
maschinen:cnc [2022/03/30 09:50] (current) ketlli |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
The CNC machine in use in the GFL is the eas Heavy 450. | The CNC machine in use in the GFL is the eas Heavy 450. | ||
Line 89: | Line 89: | ||
{{ : | {{ : | ||
+ | The last thing to do, before we move on to the computer for the start of the machine, is release the knob so that the brush is released in order to have less debris during cutting. | ||
+ | {{ : | ||
+ | Lastly, we move on to the PC. We open the program following the NC program logo, we insert the file that we have prepared for cutting by File> | ||
+ | |||
+ | {{ : | ||
+ | {{ : | ||
+ | {{ : | ||
+ | {{ : | ||
+ | |||
+ | Lastly, do not leave the CNC machine unattended at any moment while it is working. If needed to go, ask someone else to be there instead. So, finally, after releasing the doors when the CNC was done and vacuuming the leftover debris, this was the end result. | ||
+ | |||
+ | {{ : |